DMX Editor

External dimension

Interface Specifications

Power input interface:

Adopt conventional DC power Transposon as a DC power input interface,and equip with plug-DC.

DMX signal output interface:

Adopt 3-pin-Block as a signal interface

Direction for use

1.Adopt buttons control, and every button function as follows:

   Mode: query ID value of receiver module;
     para：send ID value to receiver module;
     up：ID value add 1;
    down: ID value subtract 1;

2.Connect DMX receiver module with address editor, then turn on the power for receiving module and address editor, the screen  

    shows DMX512 Editor; you can operate it as the following ways:
     ①By up,down amending ID value,the screen will display the current value of ID synchronously by Decimal number and the number of

       binary mode. for example:  Device ID:0001 Bin:00000000001, modified ID value and then press para, the screen shows  

       Sending... ,  if sent successfully,the screen shows Sending OK!;
     ②Press mode,the screen shows Looking Up... ,if queried successfully，the screen shows the value of DMX module,then continue

       to operatein accordance with the ①.

       If in the process of pressing mode or para,the screen shows Error , Please check respectively;
         A、whether the signal wire is poor contact or damaged or connected in a wrong way ;  
         B、whether turned on the power of receiver module;
         C、Whether DMX  Digital Console is already off or receiver module have been divorced from DMX Digital Console;

3.Support for amending the scope of ID value：1~1022;

4.You could only inqury or modify one receiver module at a time;

5.The signal interface that one male and one female interfaces are the same interfaces on the Address Editor is suitable for different joints of signal wire.

 Typical Applications